|
Colorado Sidewinders Association
2010
600 Outlaw Micro Sprint Rules
GENERAL
RACING RULES AND TRACK PROCEDURES APPLY
Admission
into the racing area signifies acceptance of and compliance with all El Paso
County Speedway General Rules and Guidelines. C.R.A.
reserves the right to refuse entry into the pit area for any reason.
2010
Tech Inspection must be completed before a car competes at El Paso County
Speedway.
CSA
600cc OUTLAW Micro Rules
All Drivers must be at least 12 years of age. All Drivers under the age of 18
must have a copy of a birth certificate or driver’s license and a release form
signed by both parents on file before being allowed to compete. Age requirement
may be waived at the promoters discretion.
All motors must start out as production 636cc or less four cylinder four stroke
engines. Modifications may be made after that point. All cars must have a noise
eliminating exhaust. Motors originally manufactured with more than 636cc will be
illegal. No motor manufactured with more than 636cc is legal.
Cars must weigh a minimum of 750 pounds with the Driver. Top 3 must weigh after
the feature prior to returning to your pit. Should any of these cars return to
their pits prior to weighing, they will be disqualified. Any material used for
adding weight to the car must be firmly attached.
TIRE RULE TO BE INFORCED DURING 2011 SEASON
Tires and Wheels. Any wheel size and tire combination may be used, but tires may
not exceed 22 1/2 inches in height. Wheels must be held on with 4 or more
standard lug nuts or knock-off hubs. 4 cylinder 600cc cars only; Right rear tire
must be a minimum 50 durometer compound or harder Hoosier or American Racer
(McCreary) tire. Tires may be grooved or siped. Tire durometer check should be
done at least 5 minutes after the races to allow for cool down.
All cars must have a metal firewall between Driver and engine compartment.
Minimum 24 gauge or .0625 thickness aluminum.
Chain guards will be installed on all cars using a minimum of .090 aluminum
material or equivalent.
On and off switches must be on the dash.
Roll cages shall be at least 1 1/8 inch .065 wall thickness or 1 1/4 inch .065
wall thickness.
Roll cages must have sufficient fore and aft bracing.
All cages shall be made of chromoly steel or equivalent.
All cars must be equipped with nerf bars and not exceed beyond the rear tires.
All cars must have bumpers extending beyond the front and rear tires.
Cars must have floor pans extending form the Driver’s feet to the front of the
seat.
All wet cell batteries mounted in the cockpit area must be covered and vented
outside the cockpit area.
All cars will have top wings at least 10 square feet, and a maximum of 16 square
feet.
Alcohol or racing fuel may be used. NO ADDITIVES ALLOWED. This only applies to
performance enhancers, is not meant to exclude top end lubricants. Random fuel
checks may be conducted at the conclusion of any event. The following placements
can be expected to be tested: top 3 placements in the A main.
No traction control devices of any type will be allowed.
The following safety items are REQUIRED: Name brand flame retardant uniform (SFI
RATED), five point racing style harness, racing style FLAME RETARDANT shoes, arm
restraints, flame retardant gloves, SNELL RATED HELMET (M-rated motorcycle
helmets not allowed), and neck brace or helmet restraint (cage net recommended).
All racing vehicles must have mufflers that keep their car
at 95dB
or less at 50 feet from the racing surface.
If a car fails the decibel test, it will be disqualified.
No persons except track officials and El Paso County Speedway Fire and EMS Rescue will
be allowed in the infield.
|